BikerBracket Helmet Lock Relocator

I was pretty disappointed by these. All they are is a piece of 3/32" x 3/4" x 3" mild steel with three holes drilled in it, one of them tapped. The hole that the fender bolt is supposed to go through was WAY too small. I knew that going in, as someone else who reviewed them had mentioned it. 30 seconds with a 5/16" drill bit, the drill press and some rust-oleum spray paint fixed that. The more annoying thing is the bracket isn't even cut very neatly, it looks like they used a hacksaw. When I went to put them on after the paint dried from the first fix I discovered that the the other two holes were not spaced properly either! Back to the drill press! Kudos to whomever thought of this thing, but the materials couldn't be more than $1 in bulk. For $15 (plus shipping) each I'd have expected them to at least be neatly cut. Or better yet, neatly cut and stainless steel or chromed.